Arrow AK600 Instruction Manual download pdf (Page 2)

2

STEP 1

Installing Gussets

"Starter

Hole"

1. Attach a Gusset in each corner of Floor Frame.

NOTE: On some Models, it will be necessary to

drill 1/8" (3mm) holes in the Floor Frame

at each Anchor Gusset.

2. All other Gussets (2 Kits) are to be attached

to Side Floor Frames. Bend one flange on

each of these Gussets before installing.

STEP 2

Installing Anchors

1. Make a "Starter Hole" in the ground for Anchor

by inserting a long screwdriver or similar tool

through the large hole in Gusset and into the

ground. Push tool straight down into the

ground approximately 10" (25cm) at each

Anchor. Remove the tool and soak the ground at

the "Starter Holes" with water.

NOTE: If ground is very loose, sandy or contains

rocks, refer to the "Helpful Hints".

2. Move Floor Frame away from "Starter Holes' to

install Anchors in the ground.

Insert sharp point of Anchor into "Starter Hole".

Keep a steady downward pressure on Anchor

while turning it clockwise into the ground. Use a

1/2" (13mm) steel bar, iron pipe or similar tool

through the eye of the Anchor. Apply even

pressure on both sides of the tool while turning.

Corner

Gusset

On some Models

(drill 1/8" 3mm holes)

Side

Gusset

Bend

One Flange

Flat

(Before Installing)

PU2

3.

1 2 3 4

Comments to this Manuals

No comments